⑶There are air bladder on the edge of the glass open the silicone vacuum bag too early

Breakdown Analysis of EVA Vacuum Glass Laminating Machine

(Notes: the following is a general guide, there is no guarantee that
they are all correct or suits your laminating machine. )

Unusual broken Reason solution

⑴Some part of film do not dissolve inside the finished laminated glass
heating not average, circle wind is not big enough, blower wire
connect wrong ①change the blower wire
②adjust the blower
③prolong the high temperature keeping time

⑵there are air bladder on the surface of the finished laminated
glass ①4 corner did not stick steady. ①stick 4 corners well
②Silica vacuum bag is leaking ②amend the silicone vacuum bag
③Vacuum pipe did not connect well ③check the vacuum pipe
④vacuum indicator do not reach the low point ④change the oil of the vacuum pump
Glass not flat enough Use better quality of glass

⑶There are air bladder on the edge of the glass
open the silicone vacuum bag too early
⑷Machine start switch get to stop from time to time Machine get wet or
there is water in it Air-dry it
⑸cannot process as setting program ①the electricity wire loose
①connect the wire well
②temperature and timing indicator broken ②Adjust the temperature
indicator and calculator graph
(6)Heating the machine too slow Heating elements broken Adjust the
current indicator, change the heating element

(Notes: the knowledge here is a general guide, there is no guarantee
that they are all correct or suits your laminating machine. )

Copyrights:
UCOLIN SILICONE TECH
(1)-Silicone Vacuuming Bag for EVA Glass Laminating Machine/Privacy
Glass Laminating
(2)-Silicone Sheet for EVA Glass Laminating Machine
(3)-Silicone Bag for PVB Glass Laminating Auto-clave
(4)-Silicone Rubber Sheet for Solar Cell Module Laminating Machine
(5)-Contact Us: uc@ucolin.com / www.ucolin.com
umewe360@gmail.com/ umewe360@hotmail.com